Video Tutorial provided by Rock Paracord

Materials Needed

Paracord – 15 feet
Side Release Buckle
Watch Face
Ruler or Tape Measure
Scissors
Lighter
Forceps

Step 1

Fold off paracord at about 2′ and run through the female end of the side release buckle.Fold off paracord at about 2′ and run through the female end of the side release buckle.

Step 2

Run both strands through the watch face(keep strands in the middle of the watch face). It should sit about middle of overall length of band.

Step 3

Put remaining male end of the side release buckle on. You will want to determine the length that you are wanting the watch to be at this point.

Step 4

Run both strands back through the watch face (keep strands on the outside of the previous two strands).

Step 5

Put strands through the female end.

Step 6

Now take the longer piece of paracord and start the weave. The weave pattern is over, under, over. Then under, over, under. Repeat steps until you reach the watch face. Tighten as you go along.

Step 7

Pull paracord through middle of watch band.

Step 8

Finish the watch with the same weave.

Step 9

Tuck loose strand into the weave, cut and burn ends. FINISHED!